Strong timber counter tops are all-natural products constructed from wood from trees around 120 years old. Wood is a living product and the more dampness receives, the a lot more the timber countertop will certainly increase. The wood we utilized in strong timber worktops has been previously kiln dried out to a moisture level of 6%, as well as it is consequently important that the worktop is not subjected to a frequently high level of humidity. Typically the moisture degree in cooking areas is approximately 50-70%.
The solid wood top need to be affixed to the cabinet box using only wood screws and also washers. It is not recommended whatsoever to glue the top on the cupboard box; the leading as well as package increase and also get at various prices, consequently splits could at some point show up, most likely on the closets' surface area.
The correct means of setting up a strong wood top is utilizing steel dealings with along the cupboard box (see our web page).
The steel correctings need to be consistently dispersed throughout the size of the top, spaced at a 1' - 1.5' distance from each various other. Across the size, the top is normally repaired to each steel support with 3 screws, one in the center, one toward the front side and one towards the rear side. The supports have to be completely leveled; or else tensions can create in the wood, bring about warping, cupping, click to read or splits.
We recommend pre-drilling the screw openings into the wood kitchen counter, in order to prevent splits as well as divides. For the same reason, it is an excellent idea not to over tighten the screws. The ending up will considerably reduce the level of such movements, however will certainly not remove them altogether. Because of the panel's laminated framework, the lengthwise activities are unimportant, so the installer must take note of the movements occurring across the panel's width. In order to stop the growth of internal stress, the openings in the steel repairings ought to be lengthened in the instructions of the motions (see our internet page ).
When subjected to regular moisture degrees - i.e. 50-60% - the worktop's size will broaden by 1/12"-1/ 24", however when subjected to a degree of 80-90%, this measurement may expand by up to 1/2" or even more for some varieties. Therefore, when the back side of the counter top is set up against a wall surface, the wall surface may restrict the top's natural activities, bring about undesirable tensions in the wood. To prevent this, you can enable a 1/4"-1/ 2" joint between the wall surface and also the counter top edge and also caulk it with a slim bid of acid-free silicone.
In addition, you can securely repair the back side to the metal sustains underneath and also therefore, allow the all-natural movements to take place at the expense of the contrary edge.
In this instance, the holes in the steel mendings corresponding to the rear side will be no bigger than the screws diameter, while the openings corresponding to the middle area and the leading edge will be lengthened.
For added info pertaining to the setup of timber countertops, bar tops as well as cooking area islands, please visit our website.